Skip to content

Gutter Repair in
Maidstone & Mid-Kent

Leaking joints, cracked sections, failing brackets and overflowing downpipes all have a cause. We work out what it is and fix what needs fixing. You get a clear quote first, with no pressure to buy more than you need.

Get a Free Quote

Common Gutter Repairs

Most gutter problems fall into a handful of groups. We inspect the fault, quote it clearly and carry out only the work you agree to.

Leaking Joints

A failed seal lets water drip or pour at the join. Depending on the cause, the fix is fresh sealant or a new seal.

Cracked Sections

Sunlight and impact can crack plastic sections. A damaged section is replaced with a matching one where possible.

Sagging Gutters

Failed or missing brackets let a run sag, collect debris and overflow. New brackets restore the support.

Downpipe Problems

Blocked or crushed downpipes stop water leaving the gutter. They are cleared, or the damaged section is replaced.

Leaking Outlets

Where the gutter meets the downpipe, the outlet can crack or come loose. It can be refitted and resealed.

Gutter Realignment

Gutters need a slight fall toward the outlet. Where the fall is wrong, the brackets are repositioned so water drains again.

Our Repair Process

1
Clear the run first Debris hides faults. A joint buried in leaves often turns out to be fine, while a problem you cannot see from outside becomes obvious once the run is clear.
2
Honest inspection We find the cause of the leak, sag or overflow. If a repair is needed, we quote it clearly, part by part. If everything is fine, we say so.
3
Agree the work You decide what goes ahead. We do not start work you have not approved.
4
Check the result After the repair, the run is checked to make sure water drains as it should.

Finding the Cause Before You Spend

Overflowing water is not always a blockage. A poor fall, a loose bracket or a failed joint can all cause it. Our guide on why gutters overflow helps you tell them apart from the ground.

Many faults can be mended without a new run. For example, a sagging section may only need brackets, and a weeping joint may only need resealing. Our guide to repairing guttering without replacing it explains when this works.

Joint leaks are the most common repair. However, the right sealant depends on the material, and sealant cannot fix a cracked section. Our gutter sealant guide covers what to use and what to avoid.

Cost and Related Services

Repair prices depend on the fault, the height and the access. As a result, we quote each job individually. Our post on gutter cleaning cost in Maidstone explains how the same factors shape a quote.

A repair often follows a clean. Our gutter cleaning service clears the run with a ground-based vacuum system. In addition, our fascia and soffit cleaning service cleans the boards behind the gutter, which helps show if they are sound.

Rotten fascia boards are a common cause of sagging. Because the brackets screw into the board, a soft board cannot hold them. That is why we look at the boards before any bracket repair.

Gutter Repair Across Mid-Kent

We serve Maidstone and mid-Kent. For the town itself, see our page on gutter cleaning and care in Maidstone. Our hours are Monday to Saturday, 8am to 6pm.

Our local pages also cover gutter cleaning in Gillingham, gutter cleaning in Sittingbourne and gutter cleaning in Faversham. In addition, you can read about gutter cleaning in West Malling and gutter cleaning in Tonbridge.

To ask about a repair, send us a message through the contact form. Describe the fault and the type of home, and we will advise on the next step.

Gutter Repair FAQs

How do I know if my gutter needs repairing or replacing?
A single leaking joint or one cracked section can usually be repaired. If the run is cracked throughout, sags along its length or has turned brittle, replacement often makes more sense. We look at the whole run and advise honestly.
Can you match new sections to my existing gutters?
Often, yes, because many homes use common profiles such as half-round or ogee. Older or unusual profiles can be harder to match. We tell you what is possible when we quote.
Do you use sealant or replacement clips for leaking joints?
It depends on the cause. A joint that leaks because its seal has failed may only need fresh sealant, while a cracked or deformed seal is better replaced. Sealant on its own is not a lasting fix for a cracked section.
What causes gutters to sag?
Sagging usually means a bracket has failed, the brackets are too far apart, or the fascia behind them is rotten. Wet debris adds weight and makes it worse. A quick bracket fix is sometimes enough, but rotten fascia has to be dealt with first.
Can a repair be done without clearing the gutter first?
It is better to clear the run first, because debris hides faults. A leak that looks like a failed joint can turn out to be a blockage. A clean often shows what really needs fixing.

Book a Gutter Repair Quote

A quote is free and carries no obligation. We serve Maidstone and mid-Kent, Monday to Saturday, 8am to 6pm.

Get a Free Quote